HVDC Protection Resistor
HDVR-600kV/200mA/15kΩ HVDC Protection Resistor
Home > Systems > HVDC Test System > HVDC Protection Resistor

HDVR-600kV/200mA/15kΩ HVDC Protection Resistor

Mode: HDVR-600kV/200mA/15kΩ
Rated voltage:600kV
Rated current:200mA
Rated resistance:15kΩ
Structure:nichrome wire convolveon epoxy tube, two terminalcontact with divider.
Damping resistance include AC side protective resistance and DC side protective resistance.
Its place between DC generator and divider. Resistor’s resistance annual change less than 5%. Resistance is movable and lockable.

Protection of Over-current and Over-voltage:
When DC device external load or system component breakdown or flashover, the system may happen over-current or over-voltage phenomenon.
HV silicon rectifier is the most weak component of the DC generator. When over-voltage or over-current happne, this component easy to be damaged.
Testing prove, load (test object) short circuit is the most serious situation of over-voltage and over-current.
If serial DC generator not equip current limit resistor, when load short circuit, the left pillar C1, C2 and C3 serial connection and pass D1, D4. The high discharge current will damage D1 and D4.But if serial one current limit resistor R1, and equip enough resistance, will enable limit the discharge current in acceptable range. But the discharge current will generate voltage drop, around R1, close to (n-1)Um. This voltage drop impact neighbouring D1, D4 and transformer HV winding, causing high over-voltage.
If serial connecting one protection resistor R0 between main body of generator and load, and R0/R1 big enough, the over-current and over-voltage can be limited in acceptable range.
When HV capacitor breakdown, HV silicon rectifier will also has over-current, e.g. capacitor C2 breakdown, D2 will has high over-current,  in order to control the over-current, every HV silicon rectifier should connect with one current limit resistor R1.

Where To Buy